All tend to be slower burning than Green Dot. Future, the MEC bushing chart will only get you close. You will need to Test the thrown body weight which has a scale.



Have faith in is, the AA CF hulls have much less volume as opposed to HS hulls, and it probably not a Performing force difficulty, but just not enough room inside the hell to obtain it up around 1300fps with the essential degree of powder as an alternative.

Reviews can only be submitted whilst currently being logged in. Make sure you enter your login aspects beneath. New customer?

Two matters to indicate also, smaller grain powder wants a incredibly hot primer to get it heading (Gain 209 is fine) and needs Doing the job force to get a good burn as well.

Plainly Once i'm crimping the shell, it goes in way also deep along with the crimp does not absolutely crimp. Consequently, the direct falls out from the shell. Are you aware of what I can do to suitable this.

I wound up installing a plastic powder baffle to cut down on exact. I retain a can of bottled air helpful to help you hold down buildup at The bottom when reloading.




I take advantage of this powder because it is actually a “ball” powder, not a “adhere”. I use it in my Dillon XL650. After the powder measure is about, Each individual toss is accurate in just 0.one grains. It produces incredibly consistent ammunition.

I am able to validate from 1st hand knowledge the 13gr. load performs just like a charm that has a load of three @ 0.395" balls; my loads have been plastic shells but I see no cause why it wouldn't do the job with total duration metallic shells.

The individual accessing This great site assumes the chance of Risk-free loading practices. Failure to take action could cause serious private personal injury (or Loss of life) and/or house damage.

The data exhibited on This great site, together with ballistic data, was derived from tightly managed laboratory problems.

3 grains. Same batch of boolits confirmed less force with 410 during Sept./Oct. I never had the chance to make use of it while in the chilly of the Wintertime even though. I actually liked it over 2400 mainly because I could squeak out a lot more velocity right before top would set in...

Include to quotation Only exhibit this consumer #three · Mar seven, 2008 Acquiring shot skeet for quite a few years using the visit site 410 gauge I have reloaded my share of those shells. I'm not informed about the AAHS shells unless you might be referring to WW Double AA's. Found this gauge is quite sensitive to components utilized. Though distinct sources say there powders will work, I discovered that only a few would function with tiny troubles. Others would do one of two matters--Permit the wad seat as well lower or also high.




You don't will need any wad tension with fashionable 410 wads but altering the cam could well be your previous step about the crimp stage. Ive put in place an 8570 grabber a 600jr and a 9000 grabber plus the 410 is super finicky, but if you lastly get it you'll be satisfied! shotgunworld.com has lots of handy shotgun loaders

The shell are definetly beneath powered. Once again I'm utilizing Alliant Green Dot powder as proposed from other forums which accurate gunpowder reloading data i read through. I am open up to any solutions or assistance on these loads.